Power Integrations CAP014DG

CAP014DG is the 1000 V breakdown-voltage option in the CAPZero family for an X-capacitor selection of up to 1 microfarad with a nominal total series discharge resistance of 780 kilohms. It is intended for AC-input EMI filters that need an X-capacitor discharge path without continuous loss through the discharge resistors while the line is connected.

CAP014DG uses the Power Integrations D package, a plastic SO-8 body. The data-sheet outline gives a nominal 3.90 mm body width and a 1.27 mm lead pitch. The catalog's normalized package name is 8-SOIC.

Layout checks

• Use the manufacturer's SO-8 D-package drawing for land pattern and dimensional tolerances.
• Maintain the required creepage and clearance between the D1 and D2 sides of the package and PCB.
• Check the board's resistor placement, MOV position, and safety spacing in the final AC-input layout.

The package image is illustrative; it is not a substitute for the controlled mechanical drawing or equipment safety review.

The manufacturer's SO-8 pin configuration uses duplicate connections for each active terminal to support the specified spacing.

Confirm pin numbering and copper connections against the current manufacturer pinout before fabrication.

Selection-table resistor and capacitance values are nominal design points, not interchangeable device ratings. Absolute-maximum ratings do not imply continuous-operation limits.

CAP004DG shares the 1-microfarad and 780-kilohm selection row but belongs to the 825 V breakdown-voltage group. It is only a conditional engineering candidate: recheck MOV placement, differential surge requirements, worst-case terminal voltage, package, and approvals before considering it. Other CAPZero ordering options use different X-capacitor and resistor selection rows and are not automatic substitutes. Newer CAPZero generations require their own schematic, pinout, and safety review.

Power Integrations documents CAP014DG in its CAPZero family data sheet, Rev. H. The family is designed to reduce standby dissipation associated with X-capacitor safety-discharge resistors in AC-input power converters. Confirm the document revision and lifecycle status during sourcing and design release.

Check the full CAP014DG marking, SO-8 package, traceability, and purchase documentation against the manufacturer's controlled information. Verify material declarations and qualification records for the exact shipment as needed; this page does not certify an individual lot.

This summary supports preliminary selection, not equipment certification. Validate X-capacitor discharge time, resistor ratings under fault conditions, surge margin, creepage, clearance, thermal behavior, and applicable safety standards in the complete system. Use the latest manufacturer data sheet as the final technical authority.