Analog Devices Inc./Maxim Integrated MAX4506CSA

The MAX4506 places three independent fault-protected paths between analog inputs and outputs. Signals within the supply rails pass through, while a fault on an input causes its output to clamp toward the appropriate supply rail. The paths open when power is removed. Designs may use unipolar or bipolar supplies within the manufacturer's operating ranges.

Maxim's ordering table specifies MAX4506CSA as an 8-pin SO package, 0 C to +70 C. The package is the narrow 0.150-inch SOIC class; LCDChip registers it as 8-SOIC (0.154", 3.90 mm width). Verify the controlled outline, land pattern and pin-one mark for board release.

Layout checks

• Keep fault-facing IN traces separated from protected OUT nodes.
• Confirm V+ and V- supply routing and decoupling.
• Check pin-one orientation against the manufacturer drawing.

This generic JPG does not show device-specific pins.

The MAX4506 SO/DIP top-view diagram assigns pins 1, 2 and 3 to IN1, IN2 and IN3; pin 4 to V-; pins 5, 6 and 7 to OUT3, OUT2 and OUT1; and pin 8 to V+. Each numbered IN/OUT pair forms one protection path. Confirm the top-view orientation and supply polarity before routing.

Protection ranges and electrical limits have conditions; consult the controlled data sheet for current, timing and test details.

A same-size SOIC or newer plus-suffixed order code is not automatically interchangeable. Confirm three-channel pinout, supply topology, protected fault range, output clamp current, on-resistance, temperature grade, package materials and lifecycle. No unverified internal alternative link is asserted.

Maxim Integrated's MAX4506/MAX4507 Fault-Protected, High-Voltage Signal-Line Protectors data sheet, 19-1415 Rev 2, documents the exact MAX4506CSA ordering code, SO/DIP pin configuration, fault behavior and electrical characteristics. Analog Devices now hosts the manufacturer data sheet and product family information.

Verify the complete MAX4506CSA order code, 8-pin narrow SOIC package, markings, lot label and traceability. Incoming electrical checks should cover path continuity under nominal conditions and appropriate fault isolation under controlled test limits.

Use the current Analog Devices-hosted MAX4506/MAX4507 data sheet, package drawing and applicable notices for final design approval. Verify power sequencing, fault current, protected-device ratings and thermal limits; the presence of a protector does not remove system-level surge and safety requirements.